• Inicio
• koss porta pro
• Free STL file MMCX Connector Mod for Koss Porta Pro headphones 🎧・Design to download and 3D print・Cults

Free STL file MMCX Connector Mod for Koss Porta Pro headphones 🎧・Design to download and 3D print・Cults

4.6 (183) · € 25.00 · En stock

(New version, which uses a nut to retain the MMCX connector, has been added) Removeable cables makes everything classier, especially the now ubiquitous Koss Porta Pros. This model is a holder for an MMCX connector. The connector can be found on and should be the shorter (8.5mm overall length) M3 threaded version. The holder will need the mounting hole drilled and tapped out to M3. The two screws used are M2x6mm button heads. They screw straight into the pre-existing holes on the driver back and don't require the holes to be drilled or tapped. The inner pin should be wired to the driver where the red or green signal wire was soldered and the outer tap should connect to the gold ground wires position. The cable I used is a generic MMCX one for the Shure SE425s as well as many others, from . I had to cut off the stiff shaped sheathing on the wires at the MMCX connector ends.

koss 3D Models to Print - yeggi

Koss best 3D printer models・8 designs to download・Cults

Free STL file KSC75 Cush Mod 🎧・3D printer design to download・Cults

quest 3 koss 3D Models to Print - yeggi - page 18

STL file KSC75 IEM Adapter 🎧・Design to download and 3D print・Cults

koss ksc75 mmcx adapter by 3D Models to Print - yeggi - page 5

Modded my KSC75 [mmcx mod with 3D printed adapter] : r/headphones

Ultimate Guide] Koss Modification – Ear Pads, MMCX Sockets, and Detachable Cables, Oh My!

STL file KSC75 IEM Adapter 🎧・Design to download and 3D print・Cults

Modded Koss ksc75 (mmcx mod, 3D printed headband and grills, yaxi headpads, effect audio cable) : r/headphonemods

Free STL file MMCX Connector Mod for Koss Porta Pro headphones 🎧・Design to download and 3D print・Cults

Free STL file KSC75 Cush Mod 🎧・3D printer design to download・Cults

Modded my KSC75 [mmcx mod with 3D printed adapter] : r/headphones

koss portapro 3D Models to Print - yeggi

[KSC75 Froggie Mod is a removable cable mod for KSC75. This model is for MMCX connectors.], (NOW with added EZ Print STL to print as one part),

KSC75 Froggie Mod MMCX