• Inicio
• obd 2
• Introducing the OBD-II UART Adapter for Arduino (with built-in MPU-6050) - Other Hardware Development - Arduino Forum

Introducing the OBD-II UART Adapter for Arduino (with built-in MPU-6050) - Other Hardware Development - Arduino Forum

4.6 (507) · € 9.99 · En stock

The OBD-II UART Adapter for Arduino works as a data bridge between vehicle's OBD-II port and the serial UART of Arduino, used for reading out data such as speed or engine RPM from car's ECU computer. With dedicated Arduino library, it is extremely simple to perform a readout on Arduino. The adapter embeds a MPU-6050 accelerometer/gyro/temperature sensor module inside with I2C interface. The accelerometer can be used for measuring a car's acceleration and steering G-force. The gyroscope can be us

How to get the best out of this forum - IDE 1.x - Arduino Forum

SOLVED] Failed to connect to ESP32: Timed out waiting for packet header

Introducing the OBD-II UART Adapter for Arduino (with built-in MPU-6050) - Other Hardware Development - Arduino Forum

How can I be engaging the arduino mega with OBD-II UART card? - Arduino Stack Exchange

5' OBD-II Memory Cord (Blue-Point®), EECS5MEM, obd 2

Wiring for 2 MPU6050s and an Arduino Uno? - Sensors - Arduino Forum

Is it possible to connect an Arduino to an ECU? - Quora

SparkFun OBD-II UART burned car fuse - Project Guidance - Arduino Forum

Can't find MPU6050 connected to TCA9548A multiplexer - Project Guidance - Arduino Forum

How to get the best out of this forum - IDE 1.x - Arduino Forum

Mpu6050 and Servo - Programming Questions - Arduino Forum

Accelerator MPU-6050

Les fausses plaques circulent-elles?, plaque d'immatriculation